Whirlpool Fridge Repair
Freezer is cold, but the fridge is warm. I test the defrost thermostat and heater to fix the airflow, with daily dispatch through Burnaby.
Need appliance repair in Burnaby? $149.95 diagnostic applied to your repair, 7 days a week, 6:30 AM–9:30 PM. Call 604-510-0707.
Serving homeowners in and around Burnaby: Top rated Appliance Repair Service in Burnaby. Our appliance service technicians have provided honest, accurate diagnostics in Burnaby for over 10 years. Specializing in fixing Fridges, Washers, Dryers, Ovens, and Dishwashers.
$149.95 Diagnostic / Estimation Price: Applied directly to the cost of your repair.
From Metrotown to North Burnaby, our service fleet is equipped to handle machine failures across the city with OEM parts.
"Most service calls in Burnaby for washers full of water aren't dead motors; they are pump blockages. We clear the impeller and test the drain cycle immediately."
No surprises. Just honest, old-school appliance repair.
When you call me, I set a tight arrival window and I arrive at your door in Burnaby with a truck fully stocked with OEM parts.
I physically open up the Appliance and use a True-RMS multi-meter to find the exact broken piece. I show you the problem so you understand the fault.
If you approve the quote, I fix it right then and there. The initial diagnostic fee goes entirely towards the final repair. You get a solid guarantee.
$149.95 diagnostic, applied to your repair. Open 7 days, 6:30 AM–9:30 PM.
I don't want to come out for a 5-minute fix you can do yourself. Check these first:
Do not open up the machine if you aren't trained. Modern appliances are dangerous.
My honest advice on the lifespan of your Appliance. Expand below.
✓ Fix It: Always repair fans, defrost heaters, or control boards. These parts are affordable and bring the unit back to 100%.
✕ Replace It: If the sealed-system compressor dies on a very old unit. The labor to weld copper and recover freon is extensive.
✓ Fix It: Clogged drain pumps, snapped dryer belts, burnt thermal fuses, or bad door latches. These are simple, fast, same-day fixes.
✕ Replace It: If a front-load washer sounds like a jet engine on spin cycle and it's over 8 years old, the rear tub bearing is shattered.
✓ Fix It: Stoves last forever. Always replace burnt bake elements, bad surface switches, or ignitors. It's an easy fix.
✕ Replace It: Only if a massive power surge fries a discontinued main logic board on a unit that is over 15 years old.
✓ Fix It: Drain blockages, bad water inlet valves, or broken door latches. Very common and worth fixing.
✕ Replace It: If the plastic or stainless steel inner tub has physically cracked and is leaking water straight through the chassis. You can't patch that.
Select your exact brand below to see common issues and rapid-response solutions we provide across the region.
Freezer is cold, but the fridge is warm. I test the defrost thermostat and heater to fix the airflow, with daily dispatch through Burnaby.
Stops mid-cycle. I clear out pump blockages and test the actuator to get the drum spinning again in your North Vancouver property.
Tumbles but air is cold. I replace the thermal fuse and make sure your vent is clear for Marpole and South Vancouver homes.
Clicking and not cooling. I diagnose and replace the compressor start relay to restore cooling fast throughout East Vancouver.
Sd/5d Error (Won't drain). I safely extract the clog from the drain pump and clear the coin trap for your Mount Pleasant unit.
Runs cold after 10 mins. I isolate and replace weakened electrical heating relays common in Maytag units for owners in Oakridge.
Fridge side is too cold. I test the air damper control to restore balance in your Downtown Vancouver high-rise.
uL/UE Error (Violent shaking). I replace worn suspension rods to balance out heavy loads in your Kerrisdale home.
Squealing Noise. Full rebuild: I replace the snapped belt, idler pulley, and rollers across Kitsilano and the West Side.
SY EF Error. Freezer fan isn't blowing cold. I test and replace the evaporator fan motor to restore circulation for our Richmond residential clients.
Door won't open. I bypass the lock and replace the faulty door latch assembly, with daily dispatch through Burnaby.
i20 Error (Thinks it's full of water). I clear the sump and replace the pressure switch to prevent overflow in your North Vancouver property.
Fresh food stays warm. I diagnose the three-way diverter valve in French Door units for Marpole and South Vancouver homes.
Top Rack Dirty. I replace the diverter motor that directs water to the upper spray arms throughout East Vancouver.
Phantom beeps. I test the touch panel versus the main relay board for your Mount Pleasant unit.
Ice Maker Jammed. I clear the frozen chute and replace the auger drive motor for owners in Oakridge.
E31 Error (Overfilling). I blow out the air tube and replace the pressure sensor in your Downtown Vancouver high-rise.
E64 Error. I trace the electrical failure to a burnt element or faulty heater relay in your Kerrisdale home.
Clicking & Warm. Sporadic cooling points to a failed logic board. I install the exact OEM board across Kitsilano and the West Side.
Fills but won't wash. I diagnose and replace the mode shifter coil and sensor assembly for our Richmond residential clients.
Self-clean warped the latch. I manually unlock the door and replace the latch motor, with daily dispatch through Burnaby.
Ice bucket jammed with frost. I install redesigned OEM heater clips to permanently resolve this in your North Vancouver property.
5C / 5E Error (Won't drain). I isolate a clogged filter or replace a burnt-out drain pump for Marpole and South Vancouver homes.
HE Error (No heat). I test the coils and replace the complete heating element housing throughout East Vancouver.
Linear compressor issues. I run direct voltage tests to diagnose the inverter board for your Mount Pleasant unit.
OE or LE Error. I clear the coin trap or install an OEM Hall Sensor to get your drum spinning for owners in Oakridge.
AE/E1 Error (Base pan leak). I inspect the sump gasket to protect your floors in your Downtown Vancouver high-rise.
E15/E24 (AquaStop leak). I find and seal the microscopic base pan leak, ensuring AquaStop works in your Kerrisdale home.
F18 Error (Won't drain). I clear the front trap and scope the drain hose across Kitsilano and the West Side.
Cooling fan refuses to shut off. I diagnose the limit thermostats and main relay board for our Richmond residential clients.
After many years, you learn the quirks of every manufacturer. I stock the truck based on what breaks the most.
These are all built by the Whirlpool Corporation and share parts. If your Maytag washer won't spin, I usually know right away to check the shift actuator or the motor coupling. They are solid machines and parts are always easy to find locally here in Metro Vancouver.
Korean brands use a lot of smart electronics. For LG, if it won't spin, it's usually the Hall Sensor on the direct-drive motor. For Samsung fridges, if the ice maker freezes over, I have to install a redesigned OEM heater clip to stop it from happening again. I stock these specific parts in the truck.
If your Frigidaire fridge starts beeping with a "SY EF" code, the freezer fan died. For their front-load washers, if the door won't unlock, the latch wax motor burned out. I bypass the lock, get your laundry out, and swap the latch assembly.
German engineering is precise. Bosch dishwashers have an "AquaStop" feature. If it detects even a drop of water in the base pan, it throws an E15 error and shuts down to save your floors. I pull the unit out, find the micro-leak, and replace the sump seal.
Kenmore didn't build their own machines; they were made by Whirlpool, LG, and Frigidaire. I cross-reference the 3-digit prefix on your model number (like 110 or 795) to find out exactly who built it, so I can source the right original factory part.
GE stoves are built like tanks, but their hidden bake elements can blister over time. For their fridges, a clicking sound from the back usually means the main inverter board is struggling. I carry the universal GE parts to fix these fast.
Representative examples of what we find once the machine is open.
Line voltage failure in Burnaby. Reconstructed terminal block with ceramic insulation. Continuity restored.
Logic failure in Burnaby. Installed programmed main control board. All diagnostic error codes cleared.
The diagnostic visit is $149.95, and that amount is applied directly to the cost of your repair if you go ahead. You approve the exact quote before any work starts.
We dispatch 7 days a week, including holidays, from 6:30 AM to 9:30 PM. Call 604-510-0707 for an arrival window.
Whirlpool, Maytag, KitchenAid, Kenmore, Frigidaire, Electrolux, GE, Samsung, LG, Bosch, Inglis, Amana — and most other major brands, using genuine OEM parts.
Refrigerators, freezers, washers, dryers, dishwashers, stoves and ovens — repaired in your home, houses and condos alike.
Tell us what broke and when to reach you — we call back fast during service hours (6:30 AM–9:30 PM, 7 days).