Whirlpool Fridge Repair
Freezer is cold, but the fridge is warm. I test the defrost thermostat and heater to fix the airflow, with daily dispatch through Burnaby.
Need french door fridge repair in Burnaby? $149.95 diagnostic applied to your repair, 7 days a week, 6:30 AM–9:30 PM. Call 604-510-0707.
Serving homeowners in and around Burnaby: Top rated Appliance Repair Service in Burnaby. Our appliance service technicians have provided honest, accurate diagnostics in Burnaby for over 10 years. Specializing in fixing Fridges, Washers, Dryers, Ovens, and Dishwashers.
$149.95 Diagnostic / Estimation Price: Applied directly to the cost of your repair.
From Metrotown to North Burnaby, our service fleet is equipped to handle french door fridge failures across the city with OEM parts.
"If your freezer is ice-cold but the fridge is warm in Burnaby, it's likely a failed defrost heater. We use True-RMS meters to isolate the exact circuit fault."
Select your french door fridge issue below, and I'll tell you what I usually see when I open these up in Burnaby.
Seized evaporator fan or a shattered glass defrost tube. I pull the back freezer panel and test the heater with my multi-meter. If it's burnt out, I swap it with an OEM part to get the air flowing again.
Failed Component: Cooling System
The mechanical damper door is stuck wide open, dumping freezer air into the fridge. I check the thermistor sensors. If they read fine, I replace the motorized damper assembly so it closes properly.
Failed Component: Airflow Control
The defrost drain tube froze solid, overflowing the drip pan into the fridge. I use hot water to melt the blockage deep in the line and clean the drain valve so gravity takes the water out.
Failed Component: Drainage System
Stripped gears inside the ice maker module, or a burnt water inlet valve. I run a forced manual cycle. If power reaches the valve but no water comes out, I swap the dual-solenoid valve at the back.
Failed Component: Water Valve / Gears
The condenser fan bearings next to the compressor have dried out and seized. I check the amp draw on the fan. If it's struggling, I cut it out and wire in a sealed OEM condenser fan motor.
Failed Component: Fan Motor
The main control board failed to send power to the heater, or the heater itself broke. I do a forced defrost. If the board clicks but there's no heat, I locate the open circuit and replace the faulty element.
Failed Component: Defrost Circuit
A totally saturated water filter or a failing water inlet valve. I put a bypass plug in. If it's still slow, the primary inlet valve is calcified and I replace the entire housing.
Failed Component: Water Pressure
Massive dust blockages on the condenser coils, or a micro-freon leak. I deep clean the coils first. If it still runs non-stop without getting cold, we have a sealed system leak.
Failed Component: Sealed System / Coils
Old meat blood or spill runoff rotting in the hidden defrost pan under the unit. I pull the kickplate, extract the pan, and use industrial enzyme cleaner to kill the bacteria causing the smell.
Failed Component: Evaporator Pan
The PTC start relay shattered, so the compressor keeps trying to start and failing. I pull the relay block off the compressor. If it rattles like a maraca, it's dead. I wire in a new starter.
Failed Component: Compressor Relay
$149.95 diagnostic, applied to your repair. Open 7 days, 6:30 AM–9:30 PM.
No surprises. Just honest, old-school appliance repair.
When you call me, I set a tight arrival window and I arrive at your door in Burnaby with a truck fully stocked with OEM parts.
I physically open up the French Door Fridge and use a True-RMS multi-meter to find the exact broken piece. I show you the problem so you understand the fault.
If you approve the quote, I fix it right then and there. The initial diagnostic fee goes entirely towards the final repair. You get a solid guarantee.
We don't mess around with cheap aftermarket knock-offs. If we fix your french door fridge, we use genuine OEM parts. They fit right, and they last.
| OEM SKU | Component description |
|---|---|
241508001 | Frigidaire Defrost Tube |
W10311524 | Whirlpool Ice Maker |
WR60X10185 | GE Fan Motor |
DA32-00011C | Samsung Defrost Sensor |
AEQ73110205 | LG Ice Maker |
I don't want to come out for a 5-minute fix you can do yourself. Check these first:
Do not open up the machine if you aren't trained. Modern appliances are dangerous.
My honest advice on the lifespan of your French Door Fridge. Expand below.
✓ Fix It: Always repair fans, defrost heaters, or control boards. These parts are affordable and bring the unit back to 100%.
✕ Replace It: If the sealed-system compressor dies on a very old unit. The labor to weld copper and recover freon is extensive.
Select your exact brand below to see common issues and rapid-response solutions we provide across the region.
Freezer is cold, but the fridge is warm. I test the defrost thermostat and heater to fix the airflow, with daily dispatch through Burnaby.
Clicking and not cooling. I diagnose and replace the compressor start relay to restore cooling fast in your North Vancouver property.
Fridge side is too cold. I test the air damper control to restore balance for Marpole and South Vancouver homes.
SY EF Error. Freezer fan isn't blowing cold. I test and replace the evaporator fan motor to restore circulation throughout East Vancouver.
Fresh food stays warm. I diagnose the three-way diverter valve in French Door units for your Mount Pleasant unit.
Ice Maker Jammed. I clear the frozen chute and replace the auger drive motor for owners in Oakridge.
Clicking & Warm. Sporadic cooling points to a failed logic board. I install the exact OEM board in your Downtown Vancouver high-rise.
Ice bucket jammed with frost. I install redesigned OEM heater clips to permanently resolve this in your Kerrisdale home.
Linear compressor issues. I run direct voltage tests to diagnose the inverter board across Kitsilano and the West Side.
Representative examples of what we find once the machine is open.
Unit dispatched to Burnaby for cooling failure. Diagnostics confirmed a failed inverter control board. Installed OEM replacement and verified compressor cycle.
Field service in Burnaby completed. Resolved leakage issue via evaporator drain line evacuation and secondary heater clip installation.
Diagnostic report for Burnabyunit in : Defrost circuit open. Replaced high-limit thermostat and heating element. System normalized.
Tell us what broke and when to reach you — we call back fast during service hours (6:30 AM–9:30 PM, 7 days).