Whirlpool Washer Repair
Stops mid-cycle. I clear out pump blockages and test the actuator to get the drum spinning again for your Pointe-Claire unit.
- 50+ Years Experience in Pointe-aux-Trembles
- Fully Insured
- 7 days, 6:30 AM–9:30 PM
Expert Washer Repair Service in Pointe-aux-Trembles
Need washer repair in Pointe-aux-Trembles? $149.95 diagnostic applied to your repair, 7 days a week, 6:30 AM–9:30 PM. Call 514-700-0706.
Serving homeowners in and around Pointe-aux-Trembles: Hi, I'm Bob. I've been opening up washing machines and diagnosing fridges across Pointe-aux-Trembles for 50 years. I test it, find the exact broken part, and give you a straight path to fixing it.
$149.95 Diagnostic / Estimation Price: Applied directly to the cost of your repair.
Your local appliance technician in Pointe-aux-Trembles
“Cruising through the neighborhoods to fix a washer reminds me why I've done this for 50 years. From the busy main roads to your quiet driveway, I bring a fully stocked truck so you don't have to wait days for parts. I isolate the exact fault and fix it right the first time.”— Bob, Master Technician
Heavy Loads & Drain Clogs
"Most service calls in Pointe-aux-Trembles for washers full of water aren't dead motors; they are pump blockages. We clear the impeller and test the drain cycle immediately."
What's Actually Wrong With It?
Washer problems I see in Pointe-aux-Trembles — and how I fix them
Select your washer issue below, and I'll tell you what I usually see when I open these up in Pointe-aux-Trembles.
Washer won't drain — what usually causes it?
Coins or bobby pins jammed the drain pump impeller. I open the lower panel, physically clear the clog from the trap, and test the motor to make sure it didn't burn out.
Failed Component: Drain Pump
Washer clothes wet — what usually causes it?
A bad Hall sensor (Rotor Position) or a snapped drive belt is preventing high RPMs. I test the speed sensor communication. If it's dead, the board aborts the spin. I replace the sensor or belt.
Failed Component: Spin Cycle
Washer leaking door — what usually causes it?
A rip in the massive rubber gasket, usually from catching a zipper in the door. I pull the front chassis off, remove the tension springs, and seat a brand-new factory rubber bellows.
Failed Component: Door Bellows
Washer shaking violently — what usually causes it?
The hydraulic shock absorbers or suspension rods have lost their dampening fluid. I press down on the tub. If it bounces like a basketball, the shocks are shot. I replace the full set of four.
Failed Component: Suspension System
Washer won't agitate — what usually causes it?
Shattered motor coupling or stripped nylon agitator dogs. I tip the machine back and check the linkage. It's usually a quick fix replacing the plastic drive components.
Failed Component: Transmission / Coupling
Washer fills slowly — what usually causes it?
Hard water calcium has completely blocked the mesh screens, or the solenoids are weak. I check the hoses first. If they are clear, I ohm-test the 120V water valve and replace it if the coils are failing.
Failed Component: Inlet Valve
Washer completely dead — what usually causes it?
A broken door switch interlock. The machine won't start if it thinks the door is open. I trace the power from the wall plug to the board. Usually, I just need to swap the broken door latch assembly.
Failed Component: Power Supply
Washer stops mid cycle — what usually causes it?
The water level sensor is getting bad data from a clogged air dome tube. I blow out the pressure hose. If the sensor is still reading wrong, I replace the analog switch on the console.
Failed Component: Pressure Switch
Washer door stuck — what usually causes it?
The wax motor in the lock burned out, or there's still water in the tub. I use the manual bypass to get your laundry out, then diagnose whether the pump or the lock itself failed.
Failed Component: Door Latch Solenoid
Washer mold smell — what usually causes it?
Soap scum and bacteria buildup behind the drum from using too much cold water. I run a deep chemical descaling and physically clean the door boot where the bio-film hides.
Failed Component: Outer Tub Bearing
⚠️ Disclaimer: This is not DIY advice. Modern appliances utilize lethal high-voltage circuits. Diagnostics and repairs should only be performed by a Trained and Certified Appliance Service Technician.
$149.95 diagnostic, applied to your repair. Open 7 days, 6:30 AM–9:30 PM.
How I Work in Pointe-aux-Trembles
No surprises. Just honest, old-school appliance repair.
-
Show Up On Time
When you call me, I set a tight arrival window and I arrive at your door in Pointe-aux-Trembles with a truck fully stocked with OEM parts.
-
Test the Parts
I physically open up the Washer and use a True-RMS multi-meter to find the exact broken piece. I show you the problem so you understand the fault.
-
Fix It Right
If you approve the quote, I fix it right then and there. The initial diagnostic fee goes entirely towards the final repair. You get a solid guarantee.
The Right Parts Make the Repair
We don't mess around with cheap aftermarket knock-offs. If we fix your washer, we use genuine OEM parts. They fit right, and they last.
| OEM SKU | Component description |
|---|---|
137108100 | Frigidaire Pump |
WPW10298318 | Whirlpool Inlet Valve |
DC97-16984A | Samsung Drain Pump |
4681EA2001T | LG Drain Motor |
WH23X10030 | GE Front-Load Pump |
Before you call: quick checks and safety
Try This Before You Call Me
I don't want to come out for a 5-minute fix you can do yourself. Check these first:
- Power Check your home's main breaker panel. Sometimes it just tripped.
- Controls Make sure the "Child Lock" button wasn't accidentally held down.
⚠️ DIY Danger Warning
Do not open up the machine if you aren't trained. Modern appliances are dangerous.
- ⚡ High Voltage Electric ranges and microwaves hold lethal capacitor charges even when unplugged.
- 🌊 Flooding Messing with dishwasher pumps improperly can flood your entire kitchen or the condo below you.
Should I Fix It Or Toss It?
My honest advice on the lifespan of your Washer. Expand below.
Washers & Dryers
✓ Fix It: Clogged drain pumps, snapped dryer belts, burnt thermal fuses, or bad door latches. These are simple, fast, same-day fixes.
✕ Replace It: If a front-load washer sounds like a jet engine on spin cycle and it's over 8 years old, the rear tub bearing is shattered.
Brand Specific Repairs in Pointe-aux-Trembles
Select your exact brand below to see common issues and rapid-response solutions we provide across the region.
Maytag Washer Repair
Sd/5d Error (Won't drain). I safely extract the clog from the drain pump and clear the coin trap for owners in Longueuil.
Kenmore Washer Repair
uL/UE Error (Violent shaking). I replace worn suspension rods to balance out heavy loads to save your groceries in Terrebonne.
Frigidaire Washer Repair
Door won't open. I bypass the lock and replace the faulty door latch assembly in your Saint-Laurent home.
Electrolux Washer
E31 Error (Overfilling). I blow out the air tube and replace the pressure sensor in your Dollard-des-Ormeaux home.
GE Washer Repair
Fills but won't wash. I diagnose and replace the mode shifter coil and sensor assembly for our Montreal customers.
Samsung Washer Repair
5C / 5E Error (Won't drain). I isolate a clogged filter or replace a burnt-out drain pump throughout the Greater Montreal Area.
LG Washer Repair
OE or LE Error. I clear the coin trap or install an OEM Hall Sensor to get your drum spinning for your Saint-Laurent property.
Bosch Washer Repair
F18 Error (Won't drain). I clear the front trap and scope the drain hose from Montreal to Laval.
Typical repairs we handle in Pointe-aux-Trembles
Representative examples of what we find once the machine is open.
Washer Fixed
Customer in Pointe-aux-Trembles said their washer door wouldn't unlock. Found a burnt-out wax motor in the latch assembly. Bypassed the lock to get their laundry out, installed new latch.
Washer Fixed
Got a call for a leaking washer in Pointe-aux-Trembles. Found a tear in the rubber door boot from an overloaded spin cycle. Pulled the front panel, put a new OEM gasket on. No more leaks.
Washer Fixed
Dispatched to Pointe-aux-Trembles. The washing machine stopped mid-cycle and wouldn't drain. Cleared a baby sock out of the drain pump trap. Tested the motor, runs perfect.