Refrigerator Fixed
Got a call in Plateau-Mont-Royal. The Amana fridge was making a loud buzzing noise. Found the condenser fan motor bearings were shot. Wired in a new sealed fan motor.
- 50+ Years Experience in Plateau-Mont-Royal
- Fully Insured
- 7 days, 6:30 AM–9:30 PM
Amana Freezer Repair in Plateau-Mont-Royal
Need Amana freezer repair in Plateau-Mont-Royal? $149.95 diagnostic applied to your repair, 7 days a week, 6:30 AM–9:30 PM. Call 514-700-0706.
Serving homeowners in and around Plateau-Mont-Royal: Hi, I'm Bob. I've been opening up washing machines and diagnosing fridges across Plateau-Mont-Royal for 50 years. I test it, find the exact broken part, and give you a straight path to fixing it.
$149.95 Diagnostic / Estimation Price: Applied directly to the cost of your repair.
Your local appliance technician in Plateau-Mont-Royal
“Driving down Avenue du Mont-Royal, you can't help but admire the classic architecture. But getting a broken freezer repaired in a triplex with narrow, twisting outdoor staircases? That's where 50 years of experience pays off. I know these older electrical grids and how to fix your unit right where it sits.”— Bob, Master Technician
Cooling Failures & Defrost Issues
"If your freezer is ice-cold but the fridge is warm in Plateau-Mont-Royal, it's likely a failed defrost heater. We use True-RMS meters to isolate the exact circuit fault."
What's Actually Wrong With It?
Amana Freezer problems I see in Plateau-Mont-Royal — and how I fix them
Select your freezer issue below, and I'll tell you what I usually see when I open these up in Plateau-Mont-Royal.
Amana Freezer not cooling — what usually causes it?
Seized evaporator fan or a shattered glass defrost tube. I pull the back freezer panel and test the heater with my multi-meter. If it's burnt out, I swap it with an OEM part to get the air flowing again.
Failed Component: Cooling System
Amana Freezer freezing food — what usually causes it?
The mechanical damper door is stuck wide open, dumping freezer air into the fridge. I check the thermistor sensors. If they read fine, I replace the motorized damper assembly so it closes properly.
Failed Component: Airflow Control
Amana Freezer leaking water — what usually causes it?
The defrost drain tube froze solid, overflowing the drip pan into the fridge. I use hot water to melt the blockage deep in the line and clean the drain valve so gravity takes the water out.
Failed Component: Drainage System
Amana Freezer ice maker dead — what usually causes it?
Stripped gears inside the ice maker module, or a burnt water inlet valve. I run a forced manual cycle. If power reaches the valve but no water comes out, I swap the dual-solenoid valve at the back.
Failed Component: Water Valve / Gears
Amana Freezer loud buzzing — what usually causes it?
The condenser fan bearings next to the compressor have dried out and seized. I check the amp draw on the fan. If it's struggling, I cut it out and wire in a sealed OEM condenser fan motor.
Failed Component: Fan Motor
Amana Freezer frost buildup — what usually causes it?
The main control board failed to send power to the heater, or the heater itself broke. I do a forced defrost. If the board clicks but there's no heat, I locate the open circuit and replace the faulty element.
Failed Component: Defrost Circuit
Amana Freezer slow dispenser — what usually causes it?
A totally saturated water filter or a failing water inlet valve. I put a bypass plug in. If it's still slow, the primary inlet valve is calcified and I replace the entire housing.
Failed Component: Water Pressure
Amana Freezer running constantly — what usually causes it?
Massive dust blockages on the condenser coils, or a micro-freon leak. I deep clean the coils first. If it still runs non-stop without getting cold, we have a sealed system leak.
Failed Component: Sealed System / Coils
Amana Freezer foul odor — what usually causes it?
Old meat blood or spill runoff rotting in the hidden defrost pan under the unit. I pull the kickplate, extract the pan, and use industrial enzyme cleaner to kill the bacteria causing the smell.
Failed Component: Evaporator Pan
Amana Freezer warm clicking — what usually causes it?
The PTC start relay shattered, so the compressor keeps trying to start and failing. I pull the relay block off the compressor. If it rattles like a maraca, it's dead. I wire in a new starter.
Failed Component: Compressor Relay
⚠️ Disclaimer: This is not DIY advice. Modern appliances utilize lethal high-voltage circuits. Diagnostics and repairs should only be performed by a Trained and Certified Appliance Service Technician.
$149.95 diagnostic, applied to your repair. Open 7 days, 6:30 AM–9:30 PM.
Common Amana Freezer error codes
| Code | What it means |
|---|---|
PO | Power Outage Warning |
dE | Defrost System Fault (Heater/Bimetal) |
E1 | Thermistor Open/Short |
I Know These Brands Inside and Out
After many years, you learn the quirks of every manufacturer. I stock the truck based on what breaks the most.
Whirlpool, Maytag & KitchenAid
These are all built by the Whirlpool Corporation and share parts. If your Maytag washer won't spin, I usually know right away to check the shift actuator or the motor coupling. They are solid machines and parts are always easy to find locally here in Montreal.
Should I Fix It Or Toss It?
My honest advice on the lifespan of your Freezer. Expand below.
Refrigerators
✓ Fix It: Always repair fans, defrost heaters, or control boards. These parts are affordable and bring the unit back to 100%.
✕ Replace It: If the sealed-system compressor dies on a very old unit. The labor to weld copper and recover freon is extensive.
Typical repairs we handle in Plateau-Mont-Royal
Representative examples of what we find once the machine is open.
Refrigerator Fixed
Customer in Plateau-Mont-Royal had a warm Amana fridge. Ohm-tested the starter relay on the compressor and it was completely shattered inside. Put a new relay block on. Cooling instantly.
Refrigerator Fixed
Dispatched to Plateau-Mont-Royal for a leaking Amana refrigerator. Found a frozen defrost drain tube causing water to pool under the crisper drawers. Steamed it clear and modified the drain clip.