Cooking Fixed
Got a call in Lachine. A radiant burner on the Frigidaire cooktop wouldn't turn off, just stayed blazing hot. Pulled the back panel and swapped the fused infinite surface switch. Safety hazard resolved.
- 50+ Years Experience in Lachine
- Fully Insured
- 7 days, 6:30 AM–9:30 PM
Frigidaire Electric Stove Repair in Lachine
Need Frigidaire electric stove repair in Lachine? $149.95 diagnostic applied to your repair, 7 days a week, 6:30 AM–9:30 PM. Call 514-700-0706.
Serving homeowners in and around Lachine: Hi, I'm Bob. I've been opening up washing machines and diagnosing fridges across Lachine for 50 years. I test it, find the exact broken part, and give you a straight path to fixing it.
$149.95 Diagnostic / Estimation Price: Applied directly to the cost of your repair.
Your local appliance technician in Lachine
“Cruising through the neighborhoods to fix a electric stove reminds me why I've done this for 50 years. From the busy main roads to your quiet driveway, I bring a fully stocked truck so you don't have to wait days for parts. I isolate the exact fault and fix it right the first time.”— Bob, Master Technician
Burnt Elements & Electrical Shorts
"When an oven in Lachine won't reach temperature, we check for blistered bake elements and arced terminal blocks to ensure 240V safety."
Frigidaire Electric Stove problems I see in Lachine — and how I fix them
Select your electric stove issue below, and I'll tell you what I usually see when I open these up in Lachine.
Frigidaire Electric Stove burner won't heat — what usually causes it?
The heating wire under the glass blistered and snapped the circuit. I lift the glass top and test the coils. If the wire is broken, I install a brand-new burner box.
Failed Component: Radiant Element
Frigidaire Electric Stove burner too hot — what usually causes it?
The switch contacts fused together, sending 240V non-stop to the burner. This is a huge fire risk. I pull the back panel and swap the faulty switch block behind the dial.
Failed Component: Infinite Switch
Frigidaire Electric Stove induction flashing — what usually causes it?
A shorted transistor on the main induction generator board. Induction is complex. I pull the glass and swap the primary inverter module to restore the magnetic field.
Failed Component: Inverter Board
Frigidaire Electric Stove sparking — what usually causes it?
A loose wire at the wall cord connection arced and melted the plastic block. I cut power immediately. I snip back the burnt wires and rebuild the junction box with ceramic nuts.
Failed Component: Terminal Block
Frigidaire Electric Stove error codes — what usually causes it?
The board is getting runaway temperature readings from a faulty probe. I test the oven sensor probe. If it's reading exactly 1080 ohms, the control board is shorted and I replace it.
Failed Component: Sensor Logic
Frigidaire Electric Stove hot light on — what usually causes it?
The safety switch built into the burner box fused shut, keeping the warning light on. I have to replace the complete radiant burner assembly under the glass to fix the stuck sensor.
Failed Component: Limiter Switch
Frigidaire Electric Stove intermittent heating — what usually causes it?
A loose connection expands when it gets hot and breaks the circuit. I trace the line voltage from the switch to the element, crimping on new high-temp spade connectors.
Failed Component: Wire Harness
Frigidaire Electric Stove cracked glass — what usually causes it?
Thermal shock or a dropped cast-iron pan shattered the maintop. You cannot cook on this safely. I detach all internal burners and mount them to a new OEM glass frame.
Failed Component: Structural Hazard
Frigidaire Electric Stove touchpad glitching — what usually causes it?
Boiling steam got behind the glass and shorted out the ribbon cable. I clean the contacts with electrical cleaner. If it's permanently shorted, I install a new glass UI membrane.
Failed Component: Membrane Panel
Frigidaire Electric Stove board clicks no heat — what usually causes it?
The mechanical relay on the logic board is trying to close the 240V circuit but failing. I test the voltage coming out of the board. If power drops right there, I flash and swap the main control board.
Failed Component: Control Relay
⚠️ Disclaimer: This is not DIY advice. Modern appliances utilize lethal high-voltage circuits. Diagnostics and repairs should only be performed by a Trained and Certified Appliance Service Technician.
$149.95 diagnostic, applied to your repair. Open 7 days, 6:30 AM–9:30 PM.
Common Frigidaire Electric Stove error codes
| Code | What it means |
|---|---|
F10 | Runaway Temperature Detected |
F11 | Shorted Keypad / Stuck Button |
F30 | Open Oven Sensor Circuit |
The Right Parts Make the Repair
We don't mess around with cheap aftermarket knock-offs. If we fix your Frigidaire electric stove, we use genuine OEM parts. They fit right, and they last.
| OEM SKU | Component description |
|---|---|
316075103 | Frigidaire Bake Element |
I Know These Brands Inside and Out
After many years, you learn the quirks of every manufacturer. I stock the truck based on what breaks the most.
Frigidaire & Electrolux
If your Frigidaire fridge starts beeping with a "SY EF" code, the freezer fan died. For their front-load washers, if the door won't unlock, the latch wax motor burned out. I bypass the lock, get your laundry out, and swap the latch assembly.
Should I Fix It Or Toss It?
My honest advice on the lifespan of your Electric Stove. Expand below.
Ovens & Stoves
✓ Fix It: Stoves last forever. Always replace burnt bake elements, bad surface switches, or ignitors. It's an easy fix.
✕ Replace It: Only if a massive power surge fries a discontinued main logic board on a unit that is over 15 years old.
Typical repairs we handle in Lachine
Representative examples of what we find once the machine is open.
Cooking Fixed
Arrived in Lachine. Client's Frigidaire stove touchpad was completely unresponsive. Found steam had gotten behind the glass and shorted the ribbon cable. Installed a new UI membrane.
Cooking Fixed
The Lachinestove in Frigidaire locked its door mid-clean cycle and wouldn't open. Verified power, found the high-limit control board relay had shorted out. Put a new board in and recalibrated.